Gearbox; Bearing In Blade Spindle Hubs - Land Pride FDR2584 Operator's Manual

Section 5: Maintenance & Lubrication
DO NOT
OVERFILL!
IMPORTANT: Your mower is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
17358
5/04/12
Table of Contents
30215

Gearbox

IMPORTANT: Do not overfill gearbox with oil! Oil will
expand when hot! Make sure mower is level and oil is
cool before checking oil level.
Method 1: Unscrew top vented dipstick (#1). Wipe oil from
dipstick and screw dipstick in without tightening. Unscrew
dipstick and check oil on dipstick. If below bottom level
mark, add recommended gear lube through dipstick hole
until oil reaches top mark on dipstick. Reinstall vented
dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below bottom
of plug hole, add recommended gear lube through top
dipstick hole until oil flows out of side plug hole. Reinstall
and tighten side oil plug (#2) and vented dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flows out side plug hole in gearbox.

Bearing in Blade Spindle Hubs

Type of Lubrication: Multi-purpose Grease
FDR2572 & FDR2584 and Rear Discharge Grooming Mowers 310-262M
As
Required
25
Hours
23