Land Pride Front Roller Kit FDR2560 Assembly Instructions

Front Roller Kit
Assembly Instructions
FDR2560, FDR2572 & FDR2584 Models
Before You Start
When you see this symbol, the subsequent
!
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Your Front Roller Kit is exclusively designed for your
Land Pride groming mower. Please read these
installation instructions and your groming mower
Operator's Manual thoroughly before beginning.
Especially read information relating to safety concerns.
Also included in the Operator's Manual is important
information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some manual
sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
• Operator's Manual . . . . . . . . . . . . . . . . . 310-262M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 310-069P

General Information

These assembly instructions apply to the
below:
option listed
310-254S FRONT ROLLER ASSEMBLY

Tools required:

•
Safety Glasses
•
Work Gloves
•
Two 3/4" wrenches
•
Two 9/16" wrenches
© Copyright 2005 Printed
Front Roller
9/29/06
Assembly Instructions
A detailed listing of parts for each accessory kit is
provided on page 2. Use the list that is for your groming
mower as a checklist to inventory parts received. Please
contact your local Land Pride dealer for any missing
hardware.
Front Roller Assembly
Refer to Figure 1:
1. Remove the front two 1/2"-13 x 1 1/2" GR5 hex flange
serrated screws (#9) and reinsert from the bottom as
shown. Secure with existing 1/2" whiz nuts (#10).
Tighten nuts to 76 ft-lbs of torque.
2. Assemble brackets (#2) and (#3) to deck with
carriage bolts (#4) and flange nuts (#5).
3. Insert roller (#8) between brackets and install pin
(#1) through brackets and roller. Secure with washer
(#6) and cotter pin (#7).
17713
FDr2560, FDR2572 & FDR2572 Front Roller Assembly
Figure 1
Manual No. 310-324M
1