Section 2: Accessories & Set-Up; Accessory Equipment; Front Roller; Cutting Blades - Land Pride FDR2584 Operator's Manual

Section 2: Accessories & Set-up
Section 2: Accessories & Set-up

Accessory Equipment

Front Roller

Refer to Figure 2-1:
1. Remove the front two 1/2"-13 x 1 1/2" GR5 hex
flange serrated screws (#9) and reinsert from the
bottom as shown. Secure with existing 1/2" whiz nuts
(#10). Tighten nuts to 76 ft-lbs of torque.
2. Assemble brackets (#2) and (#3) to deck with
carriage bolts (#4) and flange nuts (#5).
3. Insert roller (#8) between brackets and install pin
(#1) through brackets and roller. Secure with washer
(#6) and cotter pin (#7).
17713
Front Roller Assembly
Figure 2-1
5/04/12
Table of Contents

Cutting Blades

There are four blade choices to select from based upon
soil condition, density of grass, and tractor horsepower.
The appearance of the finish cut may vary between low
lift and high lift blades. See your Land Pride dealer for
blade availability.

Low Lift Blades

Land Pride's low lift blades are designed for mowing over
sandy soil terrain where high suction lift is not crucial.
Sand sucked into the blades accelerates blade wear
more than normal. Low lift blades are recommended
because they produce a lower suction keeping sand
uplift and blade wear to a minimum.

Medium Lift Blades (Factory Standard)

Land Pride's medium lift blades are great when
horsepower is a concern. They produce a medium
suction to lift grass and require less horsepower than

high lift blades.

High Lift Blades
Land Pride's high lift blades develop the greatest suction
for lifting grass before cutting for that fresh clean cut look.
However, they may require more horsepower especially
when cutting tall dense grass. They are not
recommended for sandy soil conditions.

Mulching Blades

Land Pride's mulching blades are designed to chop
leaves and/or grass into smaller parts leaving your lawn
looking fresher and cleaner than ever before.

Accessory Part Numbers

Land Pride Part Numbers & Descriptions
Part No.
Front Roller Assembly
310-254S
Low Lift Blade
890-200C
890-204C
Medium Lift Blade
890-318C
890-375C
High Lift Blade
890-172C
890-171C
Mulching Blade
890-698C
890-706C
See your Land Pride dealer for blade availability.
FDR2572 & FDR2584 and Rear Discharge Grooming Mowers 310-262M
Part Description
FDR1648, FDR1660 & FDR1672
(3 blades required per mower)
FDR2572
FDR2584
(3 blades required per mower)
FDR2572
FDR2584
(3 blades required per mower)
FDR2572
FDR2584
(3 blades required per mower)
FDR2572
FDR2584
13