Operation Instructions - Nexgrill 820-0007B Instruction Manual

Outdoor table top gas grill
Hide thumbs Also See for 820-0007B:
Table of Contents

Advertisement

Available languages

Available languages

WARNING
1.
The grill and its individual shutoff valve must be disconnected from the gas supply piping system during
any pressure testing of that system at test pressure in excess of 1/2-in.PSI (3.5kpa).
2.
The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve during any pressure testing of the gas supply piping system at test
pressure equal to or less than 1/2-in.PSI (3.5kpa).
WARNING
1. Do not store spare Liquid Propane cylinders under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. If the information in item 1&2 is not followed exactly, a fire causing death or serious injury may occur.

OPERATION INSTRUCTIONS

LIGHTING THE GRILL
1. Place the legs in up position.
2. Make sure the propane cylinder is tightly treaded into
the regulator (hand tighten only).
3. Open lid. Always open lid when lighting.
4. Push and turn Main burner knob slowly to IGNITE/HIGH
(ALLUMAGE/ÉLEVÉ) as show in Fig.8, burner should light immediately.
5. If ignition does not occur in 3-5 seconds, turn the control knob "OFF."
Wait 5 minutes before attempting to re-light the grill. If the grill fails to
ignite after the second attempt, call customer service at 1- 866-984-7455
in USA and 1-800-648-5864 in Canada.
for assistance. With burner lit, gently close the lid and allow the grill to
warm up for 20-30 minuets prior to use.
Note: If the knob can't spark insert the match into the lighting rod as show
in Fig.9. Ignite the match and insert though the cooking grids to the burner.
TURNING THE GRILL OFF
1.
Turn knob to "OFF" position.
2.
Turn the propane cylinder control knob to the "OFF" position.
Caution: Do not attempt to re-light the grill without following all the lighting instructions.
3.
Allow the grill body to cool at least 30 minutes before attempting to move or transport.
10
Fig.9
Fig.8
OFF
IGNITE / HI
LO
Main Burners
OFF
2
IGNITE /
HIGH
3
1.
Push
2.
Turn knob to IGNITE/HIGH
(ALLUMAGE/ÉLEVÉ)
3.
Adjust flame
OFF
IGNITE / HI
LO
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents