Mounting The Tv On The Wall; Removing The Stand; Affi Xing The Protective Cover - Sharp LC-42G77H Operation Manual

Appendix

Mounting the TV on the wall

Removing the stand

For wall mounting with the optional bracket (AN-52AG4) remove the stand.
Before setting TV on the wall
• Remove the connected cables (DVD, VCR, etc) from the terminals.
• Detach the four caps at the 4 locations on the rear of the TV.
1
1 Unfasten the four screws used to secure the
stand in place.
2 Attach the wall mount brackets.
3
Set the TV on the wall.
Affi xing the protective cover
This TV type is designed to be hung on a wall. Affi x the supplied protective cover to the TV cabinet hole by following the
instructions below.
1
Remove the protective cover
from the backing.
NOTE
• To attach the stand, perform the above steps in reverse order.
• As the TV is very heavy, be careful when moving it.
Hex key
2
Attach the stand protective covers
(supplied with the product).
2
1 Detach the stand from the TV. (Hold the stand so
it will not drop from the edge of the base area.)
2 Use the protective cover to prevent dust from
entering the underside of TV where the stand has
been detached. (See this page.)
3
Firmly affi x the protective cover to
the cabinet hole on the bottom of
the TV.
69