Summary of Contents for La Crosse Technology WS-6118AL-IT
Page 1
This product offers: INSTANT TRANSMISSION is the state-of-the-art new wireless transmission technology, exclusively designed and developed by LA CROSSE TECHNOLOGY. INSTANT TRANSMISSION offers you an immediate update (every 4 seconds!) of all your outdoor data measured from the transmitters: follow your climatic variations in...
After 15 minutes have elapsed, the WWVB time code reception will automatically start. This reception typically takes 10 minutes in good conditions. If after 10 minutes the WWVB time has not been received, use the “SET” key to enter the set-up mode to manually set the Time, Time Zone and Date (see manual settings below). The clock will continue to search for WWVB each hour between 12am and 6am.
Page 3
MANUAL TIME SETTING In case the atomic clock is not able to detect the WWVB-signal (disturbances, transmitting distance, etc.), the time can be manually set. The clock will then work as a normal Quartz clock. Note: In 12 hours mode the time will be displayed with an additional “PM” for the time from 12:00 noon until 11:59.
Page 4
Cesium 133 atom in a vacuum. This atomic clock regulates the WWVB transmitter. After 15 minutes the WWVB tower icon in the clock display will start flashing in the top center of the lcd. This indicates the clock has detected a radio signal and is trying to receive it. When the time code is received, the WWVB tower becomes permanently lit and the time will be displayed.
FOLDOUT TABLE STAND The foldout table stand leg is located on the backside. Pull the stand out from the bottom center edge of the atomic clock, below the battery compartment. Once the foldout table stand is extended, place the atomic clock in an appropriate location.
Transmitter: 2 x AA, 1.5V batteries Battery life: about 24 months Dimensions (H x L x W) Atomic clock: 9.40“ x 8.74“ x 1.23“ / 239 x 222 x 31.4 mm Transmitter: 5.05” x 1.50” x 0.83” / 128.3 x 38.2 x 21.2 mm LIABILITY DISCLAIMER: •...
Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd.