AEG L 75270 FL User Manual
  1. Manuals
  2. Brands
  3. AEG Manuals
  4. Washer
  5. L 75270 FL
  6. User manual

AEG L 75270 FL User Manual

Hide thumbs Also See for L 75270 FL:
Table of Contents

Advertisement

Quick Links

See also: User Manual
EN User manual
L 75270 FL
L 75470 FL
L 75670 FL

Advertisement

Table of Contents
loading

Related Manuals for AEG L 75270 FL

Summary of Contents for AEG L 75270 FL

  • Page 1 EN User manual L 75270 FL L 75470 FL L 75670 FL...

  • Page 2: Table Of Contents

    14. INSTALLATION ............26 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...

  • Page 3: Safety Information

    ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.

  • Page 4: Safety Instructions

    • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •...

  • Page 5: Technical Information

    ENGLISH mains plug, use a 13 amp ASTA (BS • Do not touch the glass of the door 1362) fuse. while a programme operates. The glass can be hot. • • Make sure that you remove all metal objects from the laundry. This appliance complies with the •...

  • Page 6: Product Description

    Level of protection against ingress of solid particles IPX4 and moisture ensured by the protective cover, ex- cept where the low voltage equipment has no pro- tection against moisture Minimum 0,5 bar (0,05 MPa) Water supply pressure Maximum 8 bar (0,8 MPa)

  • Page 7: Control Panel

    ENGLISH 4.2 Accessories Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink.

  • Page 8: Programme Knob

    – Set again the washing programme 6.1 On Off button and all possible options. Press this button to activate or deacti- • After 5 minutes from the end of the vate the appliance. A tune sounds when washing programme. Refer to 'At the the appliance is activated.

  • Page 9: Delay Start Button

    ENGLISH • The programme time When the programme starts, the time decreases with steps of 1 mi- nute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Re- fer to 'Troubleshooting' chapter.

  • Page 10: Programmes

    10 www.aeg.com • To activate the function, press button Spin phase is off. and button at the same time until the display shows the symbol 'Rinse Hold' function is • To deactivate the function, press but- and button at the same time until the symbol goes off.
  • Page 11 ENGLISH Programme Type of load Cycle Functions Temperature max. weight of description load Extra Silent White and coloured Stop with water in STAIN 95° - Cold cotton with normal the drum EXTRA RINSE soil. Rinses TIME SAVE max. 7 kg Long spin Synthetics Synthetic or mixed...
  • Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of description load Curtains Set this programme Prewash SPIN REDUCTION 40° - Cold to wash curtains. It Wash RINSE HOLD adds automatically Rinses EXTRA RINSE the prewash phase Short spin to clean the dust from the curtains.

  • Page 13: Consumption Values

    ENGLISH programme» and the «standard 40° C cotton programme». They are the most efficient programmes in terms of combined energy and water consumptions for washing normally soiled cotton laundry. Set this programme to have a good washing results and decrease the energy consumption.

  • Page 14: Before First Use

    14 www.aeg.com Off Mode (W) Left-On Mode (W) 0.48 0.48 The information given in the charts above are in compliance with the EU Com- mission regulation 1015/2010 implementing directive 2009/125/EC. 8. BEFORE FIRST USE To activate the drain system, put 2 li- detergent dispenser.

  • Page 15: Check The Position Of The Flap

    ENGLISH The detergent compartment for the prewash phase and the soak programme. Add the detergent for prewash and soak before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme.
  • Page 16 16 www.aeg.com To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap.

  • Page 17: Setting And Starting A Programme

    ENGLISH minutes or hours. The related sym- Press button again to activate bols comes on. the appliance. Now, you can set a new washing programme. Press button , the appliance starts the countdown of the delay The appliance does not drain the start.

  • Page 18: Helpful Hints And Tips

    18 www.aeg.com When you activate the appliance – You must drain the water to open the again, the display show the end door. of the last set programme. Turn To drain the water: the programme knob to set a If necessary, decrease the spin new cycle.

  • Page 19: Care And Cleaning

    ENGLISH • If you use liquid detergents, do not set To know the water hardness in your area, the prewash phase. contact your local water authority. Obey the instructions that you find on • If your appliance has not the deter- the packaging of the products.

  • Page 20: Door Seal

    20 www.aeg.com 12.4 Door seal Regularly examine the seal and remove all objects from the inner part. 12.5 Drum • Clean the drum with special product for stainless steel. Regularly examine the drum to prevent • Start a short programme for cotton at limescale and rust particles.

  • Page 21: Drain Pump

    ENGLISH 12.7 Drain pump • The display shows an alarm code be- cause of the problem with water drain. Regularly examine the drain WARNING! pump and make sure that it is Disconnect the mains plug clean. from the mains socket. Clean the pump if: Do not remove the filter •...
  • Page 22 22 www.aeg.com Remove fluff and objects from the pump. Make sure that the impeller of the pump can turn. If this does not oc- cur, contact the service centre. Clean the filter under the water tap and put it back in the pump into the special guides.

  • Page 23: Troubleshooting

    ENGLISH Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 45°...
  • Page 24 24 www.aeg.com • • - The appliance does not drain - The anti-flood device is on. the water. WARNING! • - The appliance door is open or Deactivate the appliance before not closed correctly. you do the checks. Problem Possible cause...
  • Page 25 ENGLISH Problem Possible cause Possible solution The filter of the drain Clean the filter of the drain pump is blocked. pump. Refer to 'Care and clean- ing'. Balance problems with Adjust manually the items in the the laundry load. tub and start the spin phase again.

  • Page 26: Installation

    26 www.aeg.com Problem Possible cause Possible solution You did not remove the Use special products to remove stubborn stains before the stubborn stains. you wash the laundry. Incorrect temperature Make sure that you set the cor- was set. rect temperature.
  • Page 27 ENGLISH Remove the internal film. Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it.
  • Page 28 28 www.aeg.com Remove the power supply cable and the drain hose from the hose hold- ers. Remove the three bolts. Use the key supplied with the appliance. Pull out the plastic spacers. Put the plastic caps in the holes. You can find these caps in the user manual bag.

  • Page 29: Positioning And Levelling

    ENGLISH 14.2 Positioning and levelling • Install the appliance on a flat hard floor. • Make sure that carpets do not stop the air circulation below the appliance. • Make sure that the appliance does not touch the wall or other units •...

  • Page 30: Water Pressure

    30 www.aeg.com 14.3 The inlet hose • Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the cor- rect position. • Connect the water inlet hose to the cold water tap with 3/4 thread.

  • Page 31: Water Drainage

    ENGLISH Water-stop device The inlet hose has a water stop device. This device prevents water leaks in the hose because of its natural ageing. The red sector in the window «A» shows this fault . If this occur, close the water tap and contact the service centre to replace the hose.

  • Page 32: Environment Concerns

    32 www.aeg.com • If the end of the drain hose is this (see the drawing), you can push it directly into the stand pipe. Without the plastic hose guide. • To a sink spigot. Refer to the illustration. Put the drain hose in the spigot and tighten it with a clip.

This manual is also suitable for:

L 75470 flL 75670 fl

Table of Contents