Bissell PROHEAT 2X User Manual page 8

Operations
2. Set ReadyTools Dial to the floor cleaning
setting.
3. Plug into a proper outlet and turn the power
and heater switches to the ON ( I ) position.
Allow 1 minute for the built-in heater to warm-up
before cleaning. The PROheat 2X will be fully
warmed and will provide optimal performance
after a minute of continuous heated cleaning.
4. Cleaning Strokes. While pressing the trigger,
make one slow forward wet pass and another
one back. Caution: Do not overwet. Take care not
to run over loose objects or edges of area rugs.
Stalling brush may result in premature belt failure.
NOTE: Your machine is equipped with a circuit
breaker that will automatically shut off the
brush if a large or loose object is caught in the
brush roll. If that happens, be sure to unplug
your machine, remove the foreign object, and
then plug the machine back in to reset the
circuit breaker.
Release the trigger and make one slow
forward and backward pass over the same area
to remove any residual dirty water and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean. Continue passes
without pressing the trigger until you can't see
any more water being pulled up.
5. Remove the tank from the base of the
machine by lifting up on the tank carry handle.
Carry like a bucket to a utility sink or outside
where you will dispose of the dirty water.
a. Unlatch the top of the tank from the
bottom by lifting up on the tank latch
located on the back of the tank.
b. Remove the top of the tank by lifting up
on the handle.
Note how the lip on the top tank separates
from the groove in the bottom tank. This
placement is important when putting the
tank back together.
c. Lift the bottom portion of the tank;
pour out dirty water in the sink through
the triangular shaped opening in the corner
of the tank.
NOTE: You may notice hair & debris deposits on
the carpet or in the tank that were loosened by
the cleaning action. This debris should be picked
up and thrown away. Check the red lint filter
inside the tank for debris and remove before
continuing.
d. Fill the heavy duty bladder with clean
hot tap water and formula, following
instructions 1c through 1e on page 7.
www.BISSELL.com
8
2.
5.
5b.
5d.
800.237.7691
4.
Power Switch
Heater Switch
5a.
5c.