Front Panel Block - Sony XAV-68BT Service Manual

3-3.

FRONT PANEL BLOCK

Sheet (KEY protection) setting
Note 2: Arrange the touch panel flexible
board as shown in the figure
below before installing the sheet
(KEY protection).
– Right view
KEY board
touch panel flexible board
The hole can be seen.
Wire setting
BT ANT clamp
BT board
1 two screws
(M2.6 5 B/F)
2 two claws
9 front panel block
Note 1: When installing the sheet (KEY protection),
paste the sheet (KEY protection) after aligned
with the edge of the hole.
Do not align with the silk print.
–
OK
tape
BT ANT connector
8 Remove the BT ANT
clamp from the ditch.
4 sheet
(KEY protection)
2 claw
KEY board
NG
Aligned with the silk print.
6 tape
7 BT ANT connector
(CN803)
5 flexible flat cable
(CON702)
ditch
2 claw
1 screw
(M2.6 5 B/F)
2 claw
1 screw
(M2.6 5 B/F)
XAV-68BT
Note 3: When installing the flexible
flat cable, insert straight to
the connector.
No slanting after insertion.
OK
Insert is straight to the interior.
NG
Insert is incline
3 Remove the front panel block
in the direction of the arrow.
15