GoPro Hero 4 User Manual page 42

/ Camera Housing
To Secure the Camera in the Housing:
1. Open the housing and place the camera into position.
2. Make sure the seal around the backdoor is free of debris.
3. Close the housing backdoor and squeeze it closed to ensure a
good seal.
4. Pivot the hinged arm backwards and hook the lip of the latch into
the grooved top of the housing backdoor.
5. Push the latch down to snap it into place.
Slim housing insert camera
WARNING: Always secure the camera in its housing when using
the camera in or around water. Do not get the camera or the
battery wet.
82
Your HERO4 Silver camera comes with three types of backdoors:
Standard Backdoor, Skeleton Backdoor and Touch Backdoor.
The Standard Backdoor makes the housing
waterproof to 131' (40m). Use this door when you
need to protect the camera from water, dirt, sand
and other environmental hazards.
The Touch Backdoor (waterproof) lets you use the
Touch Display and provides waterproof protection
to 10' (3m).
NOTICE: Touch functions do not work underwater.
In extreme altitude and temperatures, keep
housing unlatched until use.
The Skeleton Backdoor (non-waterproof)
provides better sound quality by allowing more
sound to reach the camera's microphone. It also
reduces wind noise at speeds up to 100mph when
mounted on helmets, motorcycles, bikes and
other fast-moving vehicles. Use this backdoor
only when sand, excessive dirt/dust and water
damage are not a risk. This backdoor is also
recommended for use inside vehicles.
/ Camera Housing
83