GoPro Hero 4 User Manual page 24

/ Multi-Shot Mode
CAPTURING TIME LAPSE OR NIGHT LAPSE PHOTOS
1. Select the desired capture mode (Time Lapse or Night Lapse):
a. Swipe left to display the camera modes, and then tap the
upper right icon (Multi-Shot mode).
b. Swipe up to open the settings menu.
c. Tap Mode, and then tap the desired capture mode
(Time Lapse or Night Lapse).
d. Swipe down to close the settings menu. The icon for the
selected capture mode appears in the upper left on your
camera displays.
2. Press the Shutter/Select button [
countdown and the camera status lights flash each time a photo
is captured.
3. To stop capturing, press Shutter/Select button [
status lights flash three times and the camera beeps three times.
PRO TIP: When the camera is off and QuikCapture is enabled, you
can turn the camera on and immediately begin capturing Time Lapse
photos just by pressing and holding the Shutter/Select button [
Press again to stop recording and power off the camera. For details,
see Setup Mode.
46
]. The camera initiates
]. The camera
].
MULTI-SHOT SETTINGS
Three capture modes are available for Multi-Shot mode: Burst, Time
Lapse and Night Lapse. The capture mode that you select determines
the Multi-Shot settings that appear in the rest of the menu.
For instruction on how to change the following settings, see
Navigating Settings Menus.
PRO TIP: To open the settings menu for the current mode, swipe up
on the touch display or press the Settings/Tag button [
/ Multi-Shot Mode
].
47