Disassembly & Reassembly - Samsung SyncMaster 1000s Service Manual

5 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
SyncMaster 1000s (CGP1607L) monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
5-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
5-1-1 Disassembling the Cabinet
1. To uncover the 2 uppermost screws, press in
the end of each Screw Cap and pull it away
from the cabinet.
2. Remove the 4 screws on the Rear Cover and
pull it backward to remove it.
Figure 5-1
3. Remove the 6 screws on the Top Shield Cover
and remove it.
Figure 5-2
SyncMaster 1000s (CGP1607L)
4. Remove the 6 screws and Chassis ground wire
on the side of both the Left and Right Shield
and remove the Shields.
5. Remove both side screws on the lower edge of
the Stand Assembly and pull the assembly
towards you to remove it.
Figure 5-3
Figure 5-4
5-1