Samsung SyncMaster 1000s Service Manual page 14

5 Disassembly and Reassembly
5-1-2 Removing the Entire PCB Assembly
1. Complete all previous steps.
2. Using pinch-nosed pliers or long-nosed pliers,
carefully disconnect the Anode Cap from the
CRT.
3. Disconnect connector GTP901 on the CRT
Socket PCB.
4. Disconnect the CRT Socket PCB Assembly.
5. Disconnect connectors CN401_1~CN401_4,
C301_1~CN301_3, CN403, CN404 and CN405
on the Main PCB and CN605, CN606 on the
Power PCB.
Figure 5-5
6. Remove the 3 screws on the Main PCB Chassis
Bracket.
7. Lift off the entire PCB Assembly and place it
on a flat, level surface that is protected from
Static electricity.
Figure 5-6
5-2
5-1-3 Removing the CRT Socket PCB
1. Complete all previous steps.
2. Disconnect connectors CN104B, CN104RG and
G2 (GTP902) on the CRT Socket PCB.
3. Hold the CRT Socket PCB Assembly while
you lift the Cap on the CRT Socket and
desolder the two focus wires.
5-1-4 Removing the Video PCB
1. Complete all previous steps.
2. Disconnect connector CN801 on the Video
PCB.
3. Remove both side screws on the Video PCB
Assembly Rear Shield.
4. Lift off the Video PCB Assembly.
Figure 5-7
5. Remove all screws on the Video PCB
Assembly and remove the Video Shield.
6. Remove the 3 screws on the Video PCB.
7. Lift out the Video PCB and place it on a flat,
level surface that is protected from static
electricity.
Figure 5-8
SyncMaster 1000s (CGP1607L)