Before First Use - Zanussi ZDF14001WA User Manual

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to "Setting and starting
a programme".
2. Turn the programme knob until the pro-
gramme marker is aligned with
3. Press and hold, at the same time, Multi-
tab and Delay until the indicators
, and start to flash.
4. Press Multitab.
• The indicators
6
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
.
and go off.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
If you use the combi detergent tablets,
activate the Multitab option.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
• The indicator
• The display shows the current setting of
the water softener, e.g.
5. Press Multitab again and again to change
the setting.
6. Press the on/off button to deactivate the
appliance and to confirm the setting.
Filling the salt container
Caution! Water and salt can come out
,
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
continues to flash.
= level 5.
www.zanussi.com