Glowing Embers - Napoleon GD34-1NT Installation And Operating Instructions Manual

22
C
Place log #6 onto the pins on the right side of the burner.
E
Position the notch located in the bottom end of log #3 against
the centre grate post. Rest the top of log #3 into the pocket
at the top end of log #2.
Tear the glowing embers into pieces and place onto the front
row of burner ports, in front of logs #5 and #6. Care should be
taken to shred the embers into thin, small irregular pieces as
only the exposed edges of the fi bre hairs will glow when exposed
to direct fl ame; however care should be taken to not block the
burner ports. Blocked ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition.
FIGURE 46a-d
A
Place log #1 onto the burner, centering it on the log support
and pushing it as close to the rear wall of the fi rebox as
possible.
W415-0663 / A / 01.07.08
D
Sit the bottom of log #2 onto the locating pin on the left side
of the log support. Position the top of the log into the pocket
provided on the top of the rear log (#1).
F
Place the bottom of log #4 onto the locating pin on the right
side of the log support. Rest the top into the pocket provided
on the center log (#3).

GLOWING EMBERS

FIGURE 45
BGD34-1 LOG SET
B
Sit the bottom of log #2 onto the locating pin on the left side
of the log support. Position the top of the log into the pocket
provided on the top of the rear log (#1).
# 5
# 6
FRONT BURNER PORTS