Door Removal / Installation; Door Glass Replacement; Logo Placement; Log Placement - Napoleon GD34-1NT Installation And Operating Instructions Manual

DOOR REMOVAL / INSTALLATION

Place the bottom of the door into the retaining bracket.
Pivot the top of the door to the fi rebox and secure with the
door latches.
FIGURE 41
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER® logs glow when
exposed to direct fl ame and provide a unique and realistic glowing effect. Use only certifi ed PHAZER® logs available from
your Napoleon® / Wolf Steel Ltd. dealer.
Positioning the logs improperly will cause fl ame impingement and carboning.
Log colours may vary. During the initial use of the fi replace, the colours will become more uniform as colour pigments burn
in during the heat activated curing process.
FIGURE 44a-f
A
Place log #1 onto the burner, centering it on the log support
and pushing it as close to the rear wall of the fi rebox as
possible.
FINISHING
1. Place the door frame
face down careful not to
scratch the paint.
2. Center the gasketed
glass inside the door
frame with the thick
side of the gasket fac-
ing up.
3. Bend the glass re-
tainers located along
the edge of the door
frame over the gasket
holding the glass in
place. Careful not to
break the glass.
NOTE: Care must be taken when removing and disposing of any
broken glass or damaged components. Be sure to vacuum up
any broken glass from inside the fi replace before operation.
Remove the backing of the
logo supplied and place on
the glass viewing door, as
BGD34-1
indicated.
SHOWN

LOG PLACEMENT

GD34-1 LOG SET
Place the charcoal piece (log #5) onto the pins on the left
side of the burner.

DOOR GLASS REPLACEMENT

GASKET
GLASS
RETAINER

LOGO PLACEMENT

FIGURE 43
B
21
FIGURE 42
GLASS
DOOR FRAME
½"
LOGO
½"
W415-0663 / A / 01.07.08