Panasonic DMR-EH50 Operating Instructions Manual page 21

Removing Interference
≥When connecting to a television with RF socket only (
TV screen
Picture with interference
In some cases, interference (lines or patterning) or a very poor
picture may appear on the TV screen when this unit is connected.
Follow the steps below to change the video playback channel (RF
output channel) to remove the interference.
1
Press [FUNCTIONS] for more than 5
seconds.
Unit's display
RF output channel number appears.
TV screen
RF OUTPUT CHANNEL
CH :
SELECT
ENTER
Test pattern screen appears.
2
Press [W X CH] to select a channel
number, which differs by 2 or 3 from
the present channel number.
e.g. If the original channel number was 28, enter 31.
The test pattern screen disappears.
3
Re-tune your TV until you receive the
test pattern screen.
RF OUTPUT CHANNEL
CH :
SELECT
ENTER
If you can't see the test pattern screen clearly, repeat step 1
and 2 to select RF output channel again.
4
Press [ENTER] to finish this setting.
Clear picture
17)
DVD
28
RETURN
DVD
31
RETURN
VIDEO Plus+ system for Satellite/
Digital terrestrial stations
This unit doesn't recognise PlusCode numbers for Satellite stations
or Digital terrestrial stations.
The following operation also allows you to use PlusCode numbers
to make timer recordings for satellite and digital terrestrial stations.
As the settings indicated below are dummy timer recordings,
delete them in step 6.
Preparation
Turn on the Satellite/Digital terrestrial receiver(s).
Select a correct station.
1
Press [VIDEO Plus+].
VIDEO Plus +
Remain HDD 30:24 SP DVD
12:53:00 15/ 7 TUE
Enter PlusCode Number by using 0-9 keys.
2
Press the numbered buttons to enter
a PlusCode number for a satellite
station (e.g. Sky One) or digital
terrestrial station.
Press [2] to move back to correct a digit.
3
Press [ENTER].
"-- ---" will appear under "Name".
TIMER Remain HDD 30:24 SP DVD
RECORDING
12:54:00 15/ 7 TUE
HDD
Name Date Start Stop Mode
DVD
15/ 7 TUE 19:00 20:00 HDD SP
Programme Name
4
Press [3, 4] to select the channel or
AV input that is to be used for
recording from the satellite station or
digital terrestrial station.
TIMER
Remain HDD 30:24 SP DVD
RECORDING
12:56:00 15/ 7 TUE
HDD
No. Name Date Start Stop Mode
DVD
01 15/ 7 TUE 19:00 20:00 SP
AV2
New Timer Programme
5
Press [ENTER].
The channel or AV input corresponding to the PlusCode
number is memorised.
Repeat steps 1s5 above until you have set dummy timer
recordings for each of the satellite stations or digital
terrestrial stations that you will make VIDEO Plus+ recordings
from.
6
Press [3] to select each programme
that you have just set and press
[¢ CANCEL] to delete it from the
timer recording list.
To exit the screen
Press [RETURN].
1:58 SP
1:58 SP
PDC
OFF
1:58 SP
Disc
PDC space
OFF OK
RQT8033
21