Hdcu1500 Front Panel; Tally Indicator; Cable Alarm Indicators; Power Switch And Indicators - Sony HDCU1000 Operation Manual

HDCU1500 Front Panel

1 Tally indicator

2 CABLE ALARM indicators

3 POWER switch and indicators

4 MIC/PGM switch
5 Intercom level control
6 Intercom line selector
7 INTERCOM connector
a Tally indicator
Lights in red when this unit receives a red tally signal.
When the CALL button on the video camera, the MSU-
900 series Master Setup Unit, the RCP-700 series Remote
Control Panel, etc. is pressed, this indicator will go out if
previously lit, and light up if previously off.
This unit lights in green when this unit receives a green
tally signal.
You can attach the supplied number plate here.
b CABLE ALARM indicators
OPEN (red): Lights in red when a camera isn't connected
to the CAMERA connector on the rear panel of this
unit via an optical fiber cable.
Flashes when the connection status of an optical fiber
cable is bad.
SHORT (red): Lights in red when the power supply cord
of an optical fiber cable is short to external, or two
power supply cords are short.
Power isn't input to the camera when this indicator
lights.
c POWER switch and indicators
Turns the entire system on and off, including this unit, the
video camera, and the RCP-700 series Remote Control
Panel connected to the REMOTE connector of this unit.
The MAIN indicator and the CAM indicator light when the
power switch is turned on.
Pressing the CAM PW button of the master setup unit and
the remote control panel turns off the video camera only;
and only the CAM indicator turns off.
1
POWER CABLE
ALARM
CAM
OPEN
MAIN
SHORT
INCOM
MIC ON PROD
OFF PRIV
PGM ENG
Note
This unit has standby energy even when this switch is set
to off.
d MIC/PGM (microphone/program audio) switch
ON: Turns on the microphone of the headset.
OFF: Turns off the microphone of the headset.
PGM: Outputs the program audio to the INTERCOM
connector.
e Intercom level control
Turn to adjust the input level of the intercom.
f Intercom line selector
Selects the pathway of intercom signals output/input
through the INTERCOM connector.
PROD: Producer line.
PRIV: Producer line and engineer line are ignored, and
communication is possible only between this unit and
the video camera connected to this unit.
ENG: Engineer line.
g INTERCOM connector (XLR 5-pin)
Connect a headset.
To use a headset with a plug other than an XLR 5-pin plug,
consult a Sony service or sales representative.
HD CAMERA CONTROL UNIT
Locations and Functions of Parts
49