Mounting The Switchplate - KVH Industries TracVision 6 Technical Manual

TracVision 6 Technical Manual
Figure 2-16

Mounting the Switchplate

Support Frame and Front Cover
Before securing the switchplate to
the mounting surface, be sure to
strain relieve the wires connecting
to the switchplate connectors.
Several tie-wraps have been
provided to aid in strain relieving
the wires.
26
2.5

Mounting the Switchplate

After completing the switchplate wiring process, you must install
the switchplate itself. This process, detailed in the following
steps, is illustrated in Figure 2-16.
A. Panel Cutout
.82"
(97 mm)
2. 6"
(60 mm) 2.05"
(52 mm)
.19"
(81 mm)
1. Fit the switchplate assembly and support frame
into the panel cutout made earlier and flush to the
mounting surface.
2. Drill out four ⁄
5
3 2
settings in the switchplate support frame.
3. Drill four 3 ⁄ " (2.5 mm) holes in the mounting
3 2
surface using the countersunk holes in the support
frame as the template. Secure the support frame
and switchplate assembly to the mounting surface
using the four #6 self-cutting screws.
4. Snap the front cover into place to cover the screws
and support frame.
5. Reconnect vessel power.
B. Support Frame
/ " (2.5 mm)
2
" (4 mm) holes in the countersunk
C. Front Cover
/ " (4 mm)
5
2
54-0166