Replacing Or Installing A Dvd-Rw; Replacing The Internal Transcoder Device; Replacing Or Installing The Front Port Panel - Bosch DIP-7080-00N Installation Manual

18 en | Chassis setup and maintenance
3.4

Replacing or installing a DVD-RW

The chassis model includes a pre-installed slim DVD-RW drive.
To replace or install a DVD drive:
1.
2.
3.
4.
5.
6.
7.
3.5

Replacing the internal transcoder device

The chassis model includes an internal USB transcoder device.
Notice!
To replace or install the transcoder device, please apply to one of the Bosch RMA helpdesks.
3.6

Replacing or installing the front port panel

The chassis model includes a front port panel.
2013.09 | V2 | DOC
1 DVD-RW
Power down the system and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
If you are adding a new DVD drive:
Remove the mini-bezel (grate) from the drive bay The bezel can be removed by pulling out
the hard drive beneath the DVD drive bay, then pulling the mini-bezel forward.
If you are replacing a drive:
Locate the locking tab at the rear (left hand side when viewed from the front) of the DVD
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new DVD drive in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover (replace the unit in the rack, if necessary) and turn on the
system.
2
Installation Manual
Front Port Panel
Bosch Sicherheitssysteme GmbH
DIVAR IP 7000 2U