Replacing The Bolt In The Spe Blocking Element - Bosch SE 60 LSNi Installation Manual

Replacing the bolt in the SPE blocking element

(for example if the bolt breaks or if the bolt can no longer be moved)
The bolt can be replaced while the system is running (while it is disarmed).
Proceed as follows with the help of the appropriate mounting instructions:
1. Expose the SPE blocking element by removing the plastic cover for the bolt piece (for on-door
mounting) or the collar (built-in version). On the on-door version, it may be necessary to
unscrew the magnet contact housing.
2. Release the screws on the SPE blocking element (1) and remove the cover.
3. Slightly lift the worm gear (2) on the motor, so that the bolt (3) is released from the gear
framework.
4. Pull out the bolt.
5. Insert a new bolt.
6. Return the motor to its original position.
7. Replace the cover and tighten the screws.
8. Mount the SPE blocking element in line with the mounting instructions.
Notes on maintenance and service
11