Table of Contents
Advertisement
1.
Click on Tools > Internet Options > Connections tab.
2.
Select never dial a connection, click on Apply button, and then click on OK
button.
3.
Click on Tools and then click on Internet Options.
4.
Click on Connections and then click on LAN Settings.
5.
Make sure none of the check boxes are selected and click on OK button.
6. Click on OK button.
Netscape Navigator Users:
1.
Click on Edit > Preferences > double-click Advanced in the Category window.
2.
Click on Proxies > select Direct connection to the Internet > click on OK
button.
3.
Click on Edit again and then click on Preferences.
4.
Under category, double-click on Advanced and then click on Proxies.
5.
Select Direct connection to the Internet and click on OK button.
6.
Click on OK button.
3.
Q:
Web page hangs, corrupt downloads, or nothing but junk characters is being
displayed on the screen. What do I need to do?
A: Force your NIC to 10Mbps or half duplex mode, and turn off the "Auto-negotiate"
feature of your NIC as a temporary measure. (Please look at the Network Control
Panel, in your Ethernet Adapter's Advanced Properties tab.)
4.
Q: Why can't I connect to the Web Configuration?
A: you can remove the proxy server settings in your web browser.
Setup
6.9
BRC76N
1.
Q: Why does BRC76N 's setup page shut down unexpectedly?
A: If one of the pages appears incompletely in BRC76N 's setup pages, please click on
Logout item on the Main Menu before shutting it down. Don't keep it working. Then,
close Internet browser and open it again for going back to the previous page.
2.
Q:
I don't know how to configure DHCP.
A: DHCP is commonly used in the large local network. It allows you to manage and
distribute IP addresses from 2 to 254 throughout your local network via BRC76N .
Without DHCP, you would have to configure each computer separately. It's very
troublesome. Please Open Internet browser > Input 192.168.1.1 in the website
blank field > Select DHCP Server under the IP Config Menu. For more
information, please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).
3.
Q: How do I upgrade the firmware of BRC76N ?
A: Periodically, a new Flash Code is available for BRC76N on your product supplier's
website. Ideally, you should update BRC76N 's Flash Code using Firmware
Upgrade on the System Management menu of BRC76N Settings.
4.
Q: Why is that I can ping to outside hosts, but cannot access Internet websites?
Advertisement
Table of Contents
