Access Control - Sapido BRC76n User Manual

WPA-Mixed
802.1x Authentication
Radius
Personal (Pre-Shared
Key)
5.4.4

Access Control

Please refer Wireless Access Control
5.4.5 WPS
This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using this
feature could let your wireless client atomically synchronize it's setting and connect to the
Access Point in a minute without any hassle. SAPIDO BRC76N could support both Self-
PIN or PBC modes, or use the WPS button (at real panel) to easy enable the WPS
function.
PIN model, in which a PIN has to be taken either from a sticker label or from the web
interface of the WPS device. This PIN will then be entered in the AP or client WPS device to
connect.
PBC model, in which the user simply has to push a button, either an actual or a virtual one,
on both WPS devices to connect.
BRC76n WPS only support no encryption and WPA2
Please follow instructions below to enable the WPS function.
1. Setup Wireless LAN with WPS PIN :
(1).
Get the WPS PIN number from wireless card and write it down.
encryption key for long time. "AES" is harder to decode
comparing to "TKIP", so it can say tougher encryption
scheme than "TKIP"
Support WPA and WPA2 at the same time
For radius server authentication
* If you configure Pre-Shared Key as "Hexadecimal in 64
digits", please select "Hex (64 characters) ".
* If you configure encryption key in "8 to 63 letters in half-
width alphabets and numbers", please select "Passphrase