Sapido BRC76n User Manual page 58

300m value cloud wireless router
Hide thumbs Also See for BRC76n:
Table of Contents

Advertisement

RTS Threshold
Beacon Interval
Preamble Type
IAPP
Protection
Aggregation
Short GI
WLAN Partition
20/40MHz Coexist
RF Output Power
5.4.3
Security
is 2346.
This value should remain at its default setting of 2347. The range is
0~2347. Should you encounter inconsistent data flow, only minor
modifications are recommended. If a network packet is smaller than
the present RTS threshold size, the RTS/CTS mechanism will not be
enabled. The router sends Request to Send (RTS) frames to a
particular receiving station and negotiates the sending of a data
frame. After receiving an RTS, the wireless station responds with a
Clear to Send (CTS) frame to acknowledge the right to begin
transmission. Fill the range from 0 to 2347 into this blank.
Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. The allowed
setting range is 20-1024 ms..
PLCP is Physical layer convergence protocol and PPDU is PLCP
protocol data unit during transmission, the PSDU shall be appended
to a PLCP preamble and header to create the PPDU. It has 2
options: Long Preamble and Short Preamble.
Inter-Access Point Protocol is a recommendation that describes an
optional extension to IEEE 802.11 that provides wireless access-
point communications among multivendor systems.
Please select to enable wireless protection or not.
Enable this function will combine several packets to one and
transmit it. It can reduce the problem when mass packets are
transmitting.
Users can get better wireless transmission efficiency when they
enable this function.
Shut down the communication between the
connected wireless LAN devices.
If you set up as "Enabled", devices connected with
the router, such as a printer, will not be able to use.
Default Setting: "Disabled"
Configure 20/40MHz coexisting scheme.
If you set up as "Enabled", "20MHz" and "40MHz" will
coexist.
Normally use as "Disabled".
Default Setting: "Disabled"
Users can adjust RF output power to get the best wireless network
environment. Users can choose from 100%, 70%, 50%, 35%, and
15%.

Advertisement

Table of Contents
loading

Table of Contents