Checking/Setting The Distance Of The Magnetic Sensor; Replacing The Headlight Lamp - KTM 300SX Owner's Handbook Manual

1
38
5
mm x 3,14
Wheel circumference with standard tires = 2205 mm
4
3
6
7
Check/set distance of the magnetic sensor
The distance between the magnet
otherwise malfunctions on the speedometer might occur.
This distance can be corrected by screwing the sensor
KMH:
WS = mm x 3.14
MPH:
WS = (mm x 3.14) : 1.61
Replacing the headlight lamp/parking light lamp
Loosen both rubber bands and tilt the headlight mask to the front. Pull the
parking light lamp with holder
4
connector off the headlamp and remove rubber cap
ning clip and take the bulb out of the reflector. When changing the par-
king-light lamp, simply pull it out of the holder.
Insert a new lamp such that the noses
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the par-
king-light lamp is to be replaced, simply insert it in the holder. Reinsert par-
king-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
the mask by means of the rubber bands.
2 1
and the sensor must be 2-4 mm,
1 in or off.
2
3
carefully out of the reflector. Pull
5
. Disengage retai-
6 engage in the recesses
1
7 .When