KTM 300SX Owner's Handbook Manual page 10

SPEED/TRP2 (trip 2) display mode
The TRP2 trip meter is always active and counts to 999.9. Contrary to
TRP1, the displayed figure can be changed using the + and – buttons. This
is a very useful function for trips taken according to a roadbook.
TRP2 is activated by the first impulse received from the wheel sensor and
stops automatically 3 seconds after the last impulse is received.
+ increases the TRP2 figure
BUTTON
– decreases the TRP2 figure
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
SPEED/AVS2 (average speed 2) display mode
AVS2 shows the average speed based on the TRP2 and STP2 figures. The
calculation of this figure is activated by the first impulse received from the
wheel sensor and stops 3 seconds after the last impulse is received.
The displayed figure will deviate from the actual average speed if TRP2 was
changed manually or if STP2 was not stopped after the trip.
+ no function
BUTTON
– no function
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
SPEED/STP2 (stop 2) display mode
STP2 is a manual stop watch. Start the stop watch by pressing the + but-
ton, press again to hold. Press again to continue timing.
Press the MODE button to change to the next mode. The STP2 display will
blink in the other modes if STP2 continues to run in the background. To
stop STP2, return to the SPEED/STP2 mode and press the + button.
+ starts and stops the stop watch
BUTTON
– no function
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
3 to reset TRP2 to 0
SECONDS
3 to change to the next mode
SECONDS
3 to reset STP2 figures to 0
SECONDS
9