KTI Networks KS-2262 User Manual page 114

The overview of operation flow is quite simple. When Supplicant PAE
issues a request to Authenticator PAE, Authenticator and Supplicant
exchanges authentication message. Then, Authenticator passes the
request to RADIUS server to verify. Finally, RADIUS server replies if the
request is granted or denied.
While in the authentication process, the message packets, encapsulated
by Extensible Authentication Protocol over LAN (EAPOL), are exchanged
between an authenticator PAE and a supplicant PAE. The Authenticator
exchanges
encapsulation. Before successfully authenticating, the supplicant can
only touch the authenticator to perform authentication message
exchange or access the network from the uncontrolled port.
Supplicant's
System
Supplica
nt
PAE
This is the typical configuration, a single supplicant, an authenticator and an
authentication server. B and C is in the internal network, D is Authentication server
running RADIUS, switch at the central location acts Authenticator connecting to PC
A and A is a PC outside the controlled port, running Supplicant PAE. In this case,
PC A wants to access the services on device B and C, first, it must exchange the
authentication message with the authenticator on the port it connected via EAPOL
packet. The authenticator transfers the supplicant's credentials to Authentication
server for verification. If success, the authentication server will notice the
authenticator the grant. PC A, then, is allowed to access B and C via the switch. If
there are two switches directly connected together instead of single one, for the link
connecting two switches, it may have to act two port roles at the end of the link:
authenticator and supplicant, because the traffic is bi-directional.
112
the message to
Authenticator's System
Services
Authentica
Offered
by
Controlled port Uncontrolled port
Port Authorize
LAN
Fig. 3-40
authentication server
tor
PAE
MAC Enable
using EAP
Authentication
Server's System
Authenticat
ion
S