Maintenance; Troubleshooting; Moving And Storage - Tunturi Platinum Pro User Manual

You should start slowly at a low pedalling
speed and low resistance, because for
an overweight person strenuous exercise
may subject the heart and circulatory
system to excessive strain. As fitness
improves, resistance and pedalling
speed can be increased gradually.

Maintenance

The equipment requires very little
maintenance. Check, however, from
time-to-time that all screws and nuts are
tight.
• After exercising, clean the equipment
with a soft, absorbent cloth.
Do not use solvents.
• Never remove the equipment's protective
casing.
The electromagnetic brake forms a
magnetic field that
may damage the mechanism of a watch,
or the magnetic identification strip on a
credit or cash card, should they come
into immediate contact with the magnets.
Never attempt to detach or remove the
electromagnetic brake!
The electromagnetic brake is based on
electromagnetic resistance; resistance
level is electronically measured and
shown as watt reading on the display.
Due to the measurement system, your
Tunturi ergometer need not be re-
calibrated when assembled, serviced
and used according to this Owner's
Manual.
O w n e r ' s m a n u a l O w n e r ' s m a n u a l

Troubleshooting

Despite continuous quality control,
defects and malfunctions caused by
individual components may occur
in the equipment. In most cases it's
unnecessary to take the whole device
in for repair, as it's usually sufficient
to replace the defective part. If the
equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and
serial number of your equipment. Please
state also the nature of the problem,
conditions of use and purchase date.
If you require spare parts, always
give the model, serial number of your
equipment and the spare part number
for the part you need. The spare part list
is at the back of this manual. Use only
spare parts mentioned in the spare part
list.

Moving and storage

Please follow these instructions when
carrying and moving the equipment
about, because lifting it incorrectly may
strain your back or risk other accidents:
For transportation or moving of the
device, two grown-ups are needed.
Remain standing in front of the device
on each side and take a sturdy grip at
the handles. Lift the rear of the device
so as to lift the front of the device on the
wheels. Move the device and carefully
put it down to its new place. To prevent
the equipment malfunctioning, store in
a dry place with as little temperature
variation as possible and protected from
dust.
NOTE
Transport the equipment with caution
over uneven surfaces, for example over
a step. The equipment should never be
• •
P L A T I N U M P R O P L A T I N U M P R O
GB
23