LDC Racing Saliboats RS FEVA Owner's Manual page 45

7) Find the middle of the
8) Pass this loop through the eyelet at the
9) Pass the tails of the
4.33).
10) With the gennaker
sheet through the
11) Take the other end of the
into the block on the other side. Tie the two ends of the
Picture 4.33 Tying the Gennaker Sheets
12) Pull the gennaker
anything is twisted.
13) Finally, pull the
Picture 4.32 The Gennaker Downhaul Line
gennaker sheet
gennaker sheet
on the port side of the boat, thread one end of the
block by the port-side
gennaker
from one side to the other, as if you were gybing, to see if
gennaker down into the
and double it over to form a loop.
clew of the gennaker.
through the loop and pull it tight (see picture
shroud adjuster plate
sheet, pass it around the front of the jib, and
Picture 4.34 The Gennaker Sheet Block
gennaker chute.
gennaker
(see picture 4.34).
gennaker sheet together.