LDC Racing Saliboats RS FEVA Owner's Manual page 40

4) Pull the rope taut, and tie it off using two or three
5) Tie one end of the
using a knot on
Note: Instead of a rope loop, the RS Feva Race Jib has a metal eye at the
head. Tie the
6) Pull the jib up and tie the
(see picture 4.26). Only apply enough
jib from sagging whilst sailing.
7) To attach the jib
 Thread the
 Pull the
sheet
 Tie a
figure-of-eight knot
picture 4.27).
jib halyard onto the loop of rope sewn into the
knot.
jib halyard to this in the same way.
halyard
sheet, either:
jib sheet through the middle of the three holes on the
through until there is an equal amount either side of the sail.
in the
half
off around the horn cleat
halyard tension to prevent the front of the
jib sheet on either side of the
hitches.
head of the jib,
on the side of the
clew
clew plate
mast
plate.
(see