LDC Racing Saliboats RS FEVA Owner's Manual page 34

towards the back of the boat.
3) Thread the mainsheet
the block at the back end of the boom.
4) Thread the mainsheet
mainsheet back up to the end of the boom, and thread it through the metal eye
on the end of the
in the end of the mainsheet.
5) Unroll the mainsail.
6) Take the end of the
(not from the cleat), and tie it to the top of the
7) Put the top of the
above the gooseneck mast
8) Holding the sail
9) Pull the mainsail
keep it in line with the mast, especially when passing the
10) When the mainsail
been pulling around the outside of the shroud, and pull it forward.
11) Pull the halyard
of the mast.
12) Once the halyard
13) Take the Inglefield Clip
14) Clip the Inglefield Clip
15) Pull the halyard
through the webbing strap (with the outhaul), and through
through the
boom to which the
Picture 4.19 RS Feva 2:1 Mainsheet
main halyard that comes down the
mainsail into the opening at the bottom of the
collar.
in line with the mast, pull on the other end of the
up to the top of the mast. To make
is at the top of the mast, lead the
towards the back of the boat, until it locks in the
is cleated, bring it back around the shroud.
and thread the end of the
on to the one attached to the elastic by the
through the Inglefield Clip
block on the mainsheet
block is attached. Tie a single overhand knot
mast
mainsail
hoisting
halyard
halyard
until all the slack has been taken up.
bridle. Lead the
from the bullseye
using a knot on knot.
mast track, just
main halyard.
the mainsail
batten pockets.
tail that you have
cleat at the top
through the hole.
mast gate.
easier,