Displaying The Shot Mark Thumbnail Screen (Hd Mode Only); Adding And Deleting Shot Marks (Hd Mode Only) - Sony PMW-320K Operating Instructions Manual

divided into 12 equally-sized blocks (a clip or file
that has been divided into 12 is further divided
into 12, for 12 × 12 = 144 divisions). You can
repeat the same operation to increase the number
of division.
To return to the previous division level
Press the EXPAND button with the SHIFT button
held down, or select THUMBNAIL >Thumbnail
View >Back Expansion. The expand thumbnail
screen returns to the previous division level.
Displaying the Shot Mark
Thumbnail Screen (HD Mode
Only)
In the shot mark thumbnail screen (shown only in
HD mode), you can search for shot marks in clips
(see page 86), change index pictures (see
page 94), and add and delete shot marks (see
page 93).
1
In the thumbnail screen, select the
thumbnail of a clip, and press the
ESSENCE MARK button (see page 22)
or select THUMBNAIL >Thumbnail
View >Essence Mark Thumbnail.
The shot mark thumbnail screen appears, and
a selection list is displayed.
2
Select the type of the essence mark
thumbnail screen.
All: Thumbnail display of all frames marked
with essence marks.
Shot Mark1: Display only frames marked
with Shot Mark1 marks.
Shot Mark2: Display only frames marked
with Shot Mark2 marks.
You can also select Shot Mark 0 and Shot
Mark 3 to Shot Mark 9.
If you have recorded clips by using planning
metadata that defined names for Shot Mark 0
to Shot Mark 9, the defined names are
displayed instead of the above item names in
the list.
Example shot mark thumbnail screen
(with Shot Mark1 selected)
S1 S2
S1 S1
The properties of the clip appear at the bottom of
the screen.
Except for the following item, the information
displayed here is the same as the information
displayed in the expand thumbnail screen.
a Timecode
This is the timecode of the selected frame in the
shot mark thumbnail screen.
Adding and Deleting Shot Marks
(HD Mode Only)
In the shot mark thumbnail screen (see page 93)
or the expand thumbnail screen (see page 92),
you can add thumbnails to any frame of clips
recorded in HD mode, and delete recorded shot
marks.
To add shot marks
1
Select the frame where you want to add
a shot mark, and then select
THUMBNAIL > Set Shot Mark > Add
Shot Mark1 (or Add Shot Mark2).
The properties screen of the selected frame
appears, and a confirmation message appears
below the image.
2
Select [Execute], and press the MENU
knob.
Thumbnail Operations
S2 S1
93