Getting Started; Phone Setup - Zte cricket Prelude 2 User Manual

Getting started

Phone setup

Installing the micro-SIM card and battery
Power off your phone before installing or replacing the
battery or micro-SIM card .
1 . Insert your fingernail into the slot at the bottom
left of the back cover and lift it up gently .
2 . Hold the micro-SIM card with the cut corner
oriented as shown and slip it into the card holder .
Important: Your phone only supports micro-SIM
card . To avoid damage to the phone, do not use
other kinds of SIM cards or a non-standard micro-SIM
card cut from a SIM card . You can obtain the
standard micro-SIM card from your service provider .
3 . Carefully insert the battery with the contacts located
against the metal springs . Push down on the battery
until it is fully seated .
4 . Align the back cover with the back of the phone
and press the cover back into place . Make sure all
the tabs are secure and there are no gaps around
the cover .
8
Installing the microSDHC card (not included)
The microSDHC card can be installed and removed while the phone is
powered on . Unmount the microSDHC card before removing or replacing it .
1 . Open the microSDHC card slot .
2 . Hold your microSDHC card with the metal contacts
facing down and slide it into the card slot .
Note: Some applications may require a
microSDHC card to work normally or may store
certain data on it . Therefore, it is recommended
that you keep a microSDHC card installed and
not remove or replace it randomly .
Charging the battery
Your phone's battery should have enough power for the phone to turn on,
find a signal, and make a few calls . You should fully charge the battery as
soon as possible .
If the battery is low, there will be a pop-up message
on the screen . As you charge your phone, the screen
will tell you the exact battery level each time you wake
up your phone .
Warning! Use only ZTE-approved chargers and cables .
The use of unapproved accessories could damage
your phone or cause the battery to explode .
1 . Insert the charger's connector into the charging port . Be sure to insert
the connector in the correct orientation . Do not force the connector into
the port .
2 . Plug the charger into a standard AC wall outlet . If the phone is on, you'll
see a charging icon, such as
GETTING STARTED GETTING STARTED
or , appear on the status bar .
9