Table of Contents
Advertisement
For body worn operation, this device has been tested and meets the FCC RF
exposure guidelines for use with an accessory that contains no metal and
the positions the handset a minimum of 1 .5 cm from the body . Use of other
enhancements may not ensure compliance with FCC RF exposure guidelines .
If you do no t use a body-worn accessory and are not holding the device at
the ear, position the handset a minimum of 1 .5 cm from your body when the
device is switched on .
FCC compliance
This device complies with part 15 of the FCC Rules . Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation .
Caution: Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment .
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules . These limits
are designed to provide reasonable protection against harmful interference
in a residential installation . This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur in a particular
installation . If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
114
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.
IC
This radio transmitter (identify the device by certification number, or model
number if Category II) has been approved by Industry Canada to operate
with the antenna types listed below with the maximum permissible gain and
required antenna impedance for each antenna type indicated . Antenna
types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device .
Immediately following the above notice, the manufacturer shall provide a
list of all antenna types approved for use with the transmitter, indicating the
maximum permission antenna gain (in dBi) and required impedance for each .
IC : 5200A-MF28B
Hearing aid compatibility (HAC) regulations for
mobile phones
In 2003, the FCC adopted rules to make digital wireless telephones
compatible with hearing aids and cochlear implants . Although analog
wireless phones do not usually cause interference with hearing aids or
cochlear implants, digital wireless phones sometimes do because of
electromagnetic energy emitted by the phone's antenna, backlight, or
other components . Your phone is compliant with FCC HAC regulations (ANSI
C63 .19- 2007) . While some wireless phones are used near some hearing
devices (hearing aids and cochlear implants), users may detect a buzzing,
humming, or whining noise . Some hearing devices are more immune than
others to this interference noise and phones also vary in the amount of
interference they generate . The wireless telephone industry has developed
FOR YOUR SAFETY
FOR YOUR SAFETY
115
Advertisement
Table of Contents
