Table of Contents
Advertisement
Remote Control Description
See Figure 3 on page 16
The Home Theater Standard remote control provides on and off, input selection,
processing mode selection, speaker volume and balance adjust, and mute functions, as
well as access to the System Setup a.nd Configuration menu.
To send operational instructions directly into the Home Theater Standard using an RS-
232 based external ~;.o.ntrol device, see RS-232 Port: Sending Commands
and
Interpreting Data, the developer's reference shipped with the Home Theater Standard.
BATTERY INSTALLATION
AND REMOVAL
The Home Theater Standard handheld remote control uses two AAA-size 1.5 Volt
batteries. Batteries are included with the shipment.
To install or replace the batteries:
1. Remove the backplate, using the Torx wrench provided.
2. Install the batteries following the battery position diagram on the plastic battery
receptacle.
3. Replace the backplate.
4. The remote control is ready for operation.
Replace batteries when remote control function becomes intermittent.
Remove batteries ,if the remote control is not to be used for a long pedod of time.
Battery leakage can damage the remote control,
Home Theater Standard remote control keys and their functions are described below.
Power Functions
56 Amp Key
Use this key to power on/off a Krell remote control amplifier.
57 HTS Key
Use this key to switch the Home Theater System unit between stand-by mode and
operational mode.
Note
When you power off while zone 2 is selected, only zone 2 turns off. Press the power
button or the HTS key a second time to power off the main zone.
Krell Home Theater Standard
17
Advertisement
Table of Contents
