Jenn-Air W10297654A Installation Manual page 23

Drawer Panel
1. Using the Phillips head flat screws (provided with refrigerator),
fasten a drawer panel bracket to each side of the drawer
panel, as shown.
A
A. Drawer panel
B. Drawer panel mounting bracket
Top Grille Panel
1. Using the slotted hex head screws (provided with refrigerator),
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the Parts Provided insert sheet to select
the brackets designated for your installation.
Use the Integrated Grille brackets for an Integrated
Installation with a full height grille.
Use the Standard Grille brackets for a Standard
Installation with a flush grille, as shown.
A. Top grille brackets
B. Grille trim piece
2. Using round head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is pre installed on the panel kits.
B
A
B
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover trim pieces from the top and bottom
of the door to expose the holes in the hinges.
NOTES:
It is not necessary to remove the hinge side trims as they
will not interfere with the installation
Leave the freezer drawer trims in place for installation.
4. Remove the handle side trims. See following graphic.
A. Hinge cover pieces
B. Handle-side door trim
Install Door Panels
NOTE: French door models, first open the door opposite from the
one to which you are installing the door panel.
1. Lower the panel bracket onto the door adjustment pins at the
top of the door.
C
A. Door panel
B. Panel top bracket
2. Locate the studs on the back of the door panel. Slide the
studs, top stud first followed by the bottom stud, into the "J"
pockets in the front of the door.
NOTE: It is the washer in the stud, not the head of the stud,
that is inserted in the "J" pocket.
3. Slide the door panel down into the "J" pocket.
A
B
A
A
B
C. Adjustment pins
23