Advertisement
Input Trim
Adjust this set-and-forget control so you can play strongly without distortion and
play quietly without hiss.
To set the Input Trim:
1. Move the Image switch left to #1.
2. Hold down the Measure switch as you plug in the guitar.
3. Use a miniature jeweler's screwdriver to gently raise or lower the Input Trim so
the LED flashes occasionally with hard playing.
4. To exit the setup, unplug the guitar.
Electrical Specifications
Power consumption: 15mA
Typical 9V lithium battery life: 66 hours
Typical 9V alkaline battery life: 33 hours
Maximum output level (onset of clipping): +1dBV
Nominal output impedance: 1k Ohm
Input trim gain range: -6dB to +6dB
Peak meter response: 3dB before clipping
Voicing switch, bass boost: +3dB @ 90Hz
Dynamic range: 9 3dB
Baseline noise: -92dBV
Anti-feedback cut depth: 13.5dB
Anti-feedback bandwidth: 0.25 octave
Phase switch, out position: (+) non-inverting output
The specifications in this manual are subject to change without notice.
tel
mail -
corporate drive, suite a, escondido, ca
www.badenguitars.com
+1.760.738.0370
510
92029
Advertisement
