Battery Compartment; Ac Adapter Input; Input Jacks - Fishman POWERMIX Manual

PowerMix
Functions
BATTERY POWER
Make note of the following when using the PowerMix under battery power.
The PowerMix has no on/off switch. Under battery power, the PowerMix is
turned on when the Mix Output jack is plugged in.
To avoid excessive battery drain, unplug the Mix Output jack when the unit
is not in use (battery life is an estimated 150 hours, continuous use).

BATTERY COMPARTMENT

To install the battery, move the latch on the battery compartment in the
direction of the printed arrow and pull the latch toward you. Once the
compartment pivots out, pop open the little hinged door at the end of the
compartment and insert a fresh 9V alkaline battery. Note that the door will
not close unless the correct battery polarity has been observed.

AC ADAPTER INPUT

USE ONLY a FISHMAN model 910-R or a Roland PSA series Regulated AC
Adapter. Using an unregulated power supply will void the warranty and may
damage the unit.

INPUT JACKS

The two Input jacks are designed to accept separate magnetic and piezo
signals via a single stereo cable or a stereo "Y" cable.
The Mag / Stereo Input jack is a dual function input that will operate in
either stereo TRS, or mono TS modes. The Tip connection of this jack
receives the magnetic pickup signal from your guitar. The Ring connection
of this jack can receive the piezo signal from your Powerbridge.
The Piezo Input jack is a mono input that receives the piezo signal from
your Powerbridge.
6