About The Kontrol49 And The Driver Ports - Korg KONTROL49 Owner's Manual

Midi studio controller

Hide thumbs Also See for KONTROL49:

Installation manual (33 pages)

Table Of Contents

Table of Contents

VECTOR-Y

Specify the transmission port for the Y-axis of the vector joystick.

SW1/2

Specify the transmission port for switch 1 and switch 2.

PEDAL

Specify the transmission port for a connected foot controller.

FOOT SW

Specify the transmission port for a connected damper pedal or pedal

switch.

KEYBOARD

Specify the transmission port for the keyboard.

MAIN ENC

Specify the transmission port for program change or bank select mes-

sages sent by the main encoder.

MESG A

Specify the transmission port for MIDI messages transmitted by hold-

ing down the [MESSAGE] key and pressing a pad [2]–[8], and for MIDI

Clock messages.

MESG B

Specify the transmission port for user MIDI messages speciﬁed for

each scene and transmitted by pressing pads [9]–[16].

Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "USBPort"

(select the port).

(Red)

Use the main encoder to select the transmission port.

(Green)

A (USB Port A)

The MIDI messages assigned to the controller will be transmitted to the

computer application via port A. (See "About the KONTROL49 and

the driver ports" below)

B (USB Port B)

The MIDI messages assigned to the controller will be transmitted to the

computer application via port B. (See "About the KONTROL49 and the

driver ports" below)

Press the OCTAVE SHIFT/CURSOR [√] key to return to "Controller

Select," and specify the transmission port for other controllers.

( Steps 2–4)

When you have ﬁnished making settings for each controller, press the

[ENTER] key. The settings will be updated, and you will return to Play

mode.

If you want to keep the new settings, you must save them in Scene

mode. If you turn off the power or select a different scene without

saving, your new settings will be lost. ( p.55 "Scene mode–[16]

WRITE")

The port settings are saved independently for each scene.