Tv Antenna - Winnebago Journey Owner's Manual

• Slide the filter out of the bracket assembly at
the passenger side of the cabinet.
• Slide the new filter into the bracket, being
careful to observe airflow markings on the
edge of the filter.
A/C Filter Size: 14" x 20" x 1"
NOTE: Do not block the filter in any way, such
as by setting packages or newspapers,
etc., on top of it. There must be free air
flow for the air conditioner to operate
efficiently.
Condenser Coils
The condenser is located behind the louvered
body panel on the right side of the coach. The
condenser is the large, black, rectangular area
that looks like a car radiator. The panel is hinged
at the top edge to allow opening for periodic
cleaning or service. Remove the fasteners behind
the lower edge of the panel and swing it upward
for access to the condenser.
Periodically sweep debris carefully from the
fins of the condenser. Rinse dust off with clean
water. The condenser coils must be clean and
free of dust, debris and insect particles, etc., for
the air conditioner to cool efficiently.
Further Information
See the air conditioner manufacturer's operat-
ing instructions supplied in your Owners Info-
Case. They contain detailed operating
instructions, special precautions and basic trou-
bleshooting.
APPLIANCES & INTERIOR FEATURES

TV ANTENNA

The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna - Turn elevating crank
clockwise in "UP" direction about 13 turns or
until some resistance to turning is noted. Antenna
is now in operating position. Turn amplifier pow-
er switch "ON" to receive TV signal.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Rotating Antenna - Make sure antenna is in
the "UP" position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
SECTION 8
8-15