Comfort Controls; Heating; Defrosting; Ventilation - Winnebago Journey Owner's Manual

WINDSHIELD WASH/WIPE SWITCH
Wash: Press the control knob to pump washer
solution onto the windshield. The wiper will also
begin operating. The wiper will continue for 5
wipes after you release the washer knob.
HI
LOW
Wiper: Rotate the outer knob pointer to the
desired setting - Delay, Low or Hi.
Delay: Turn the outer knob pointer to
"DELAY". Turn the center (wash) knob to set
the time you want between wipes, from 1 second
(all the way left) to about 90 seconds (all the
way right).

COMFORT CONTROLS

AUTO AIR CONDITIONER/
HEATER
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
Temp
Fan Switch
Control
OFF
DELAY
Mode
Control
DRIVING YOUR MOTOR HOME
1. Front Heater Fan Switch
2. Temperature Control Knob
3. Mode Selection Knob

HEATING

A. For maximum heating
1. Turn the mode selection knob to HEAT
or VENT.
2. Turn the temperature control knob to
WARM (red) zone.
3. Place the fan switch to high (largest dot).
B. For reduced heating:
1. Turn the temperature control knob
toward the COOL (blue) zone to the
desired comfort position.
2. Adjust the fan speed for desired volume.

DEFROSTING

A. For maximum defrosting and defogging:
1. Turn the mode control knob to DEF.
2. Turn the temperature control knob to
WARM (red).
3. Turn the fan switch to high (largest dot).
4. Turn on auxiliary (windshield) fans if
additional air movement is needed
B. For reduced defrosting:
1. Turn the temperature control knob to the
left to an intermediate setting.
2. Adjust the fan speed for desired volume.

VENTILATION

A. To vent outside air into the vehicle when nei-
ther heating or cooling is required.
1. Turn the mode selection knob to vent.
2. Turn the temperature control knob all the
way to the left to the COOL (blue) zone.
3. Adjust the fan speed for desired volume.
SECTION 2
2-15