Multi-Function Signal Lever; Steering Tilt/Telescope; Cruise Control - Winnebago Journey Owner's Manual

SECTION 2
DRIVING YOUR MOTOR HOME
MULTI-FUNCTION SIGNAL
LEVER
The multi-function signal lever controls the
turn signals, high/low beam changing, and the
electronic speed control (cruise).
See your chassis operating guide for complete
operating information.
Multifunction Lever
Signals/Hi-Lo Beams/Cruise
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.

STEERING TILT/TELESCOPE

The tilt/telescoping adjustment lever is locat-
ed on the left side of the steering column.
To Adjust Tilt Wheel: Pull the lever toward you
and tilt the steering wheel to the desired angle,
then release the lever.
2-14
Pull to Tilt
Push to Telescope
To Adjust Telescoping Column: Push the lever
toward the dash. Push or pull the steering wheel
to slide the steering column in or out to the
desired length. Release the lever to lock the col-
umn into position.
WARNING
Do not adjust the steering column or
tilt wheel while the vehicle is in
motion. This could cause a loss of
vehicle control.

CRUISE CONTROL

The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your Freightliner chassis operator manual
for complete instructions and precautions on the
cruise control.
WARNING
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.