Appendices; Adjusting The Expression Pedal; Restoring The User Programs To The Factory Settings - Korg ToneWorks AX1000G Owner's Manual

4. Appendices

4. Appendices

Adjusting the expression pedal

(Calibration)
If you find the expression pedal difficult to use,
perform this procedure so that the pedal will function
optimally. For example if the effect does not reach
maximum when the pedal is advanced all the way, or
does not reach minimum when the pedal is returned
all the way, use the following procedure to make the
appropriate adjustments.
When making adjustments, use your hand to move the
pedal. Accurate calibration may not be possible if you use
your foot to operate the pedal.
1. Turn on the power while simultaneously holding
down the EXIT switch and the PEDAL effect block
select switch.The name display will show "PEDAL"
for approximately one second, and will then
indicate "MIN."
2. Slowly return the pedal to the full back position.
When it stops, release your hand and press the
WRITE key.The name display will change from
"MIN" to "MAX."
If you decide to halt the adjustment procedure, press the
EXIT switch. The power-on display will appear, and you
will enter Play mode.
3. Slowly advance the pedal. When it stops, release
your hand and press the WRITE key.
2. Press slowly
The LCD display will indicate "COMPLT" for
approximately one second. Then the power-on display
will appear, and you will enter Play mode.
After the adjustment procedure has been completed,
verify the operation of the pedal.
Select an effect that will make it easy to verify the
adjustment. For example, set the pedal effect block to
the VOLUME effect, set the value to 0, and check the
MIN level when the pedal is returned all the way.
If you make a mistake during the calibration procedure,
the LCD will indicate "ERROR," and you will return to the
screen before the adjustment (the "MIN" display). If the
"ERROR" display appears for repeated attempts, a
malfunction may have occurred. In this case, please
contact your dealer.
14
Restoring the user programs to
the factory settings (Reload)
3. Press slowly
1. Turn on the power while simultaneously holding
down the EXIT switch and the bank switch. The
name display will indicate "RELOAD?"
If you press the EXIT switch, the reload operation will not
occur; the power-on display will appear, and you will
enter Play mode.
2. Press the WRITE switch. The name display will
change to "RELOAD," and the reload operation
will begin. When the reload operation is completed,
the display will indicate "COMPLT" for approxi-
mately one second. Then the power-on display will
appear, and you will enter Play mode.
Never turn off the power during the reload operation.
When you perform the reload operation, all user
programs will be rewritten. Master level, metronome, and
input level settings will also be initialized.