Replacement Bulbs; Electrical System; Overload - Chevrolet 2013 Cruze Owner's Manual

3. Turn the bulb socket
counterclockwise and pull
straight out of the lamp
assembly.
4. Remove the bulb by pulling it
straight out of the socket.
5. Push the new bulb into the
socket.
6. Install the bulb socket by turning
clockwise into the license plate
lamp assembly.
7. Replace the license plate lamp
assembly and tightien the two
screws to secure.

Replacement Bulbs

Exterior Lamp
Number
Back-Up Lamp
Front and Rear
Sidemarker
Front Parking/Turn
Signal Lamp
High Beam/Low
Bean and DRL
Headlamp
License Plate Lamp W5W LL
Rear Turn
Signal Lamp
Stoplamp/Taillamp 3057K LCP
For replacement bulbs not listed
here, contact your dealer.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care

Electrical System

Bulb
Electrical System

Overload

921K
The vehicle has fuses and circuit
194
breakers to protect against an
electrical system overload.
7444NA
When the current electrical load is
too heavy, the circuit breaker opens
H13LL
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
greatly reduces the chance of circuit
overload and fire caused by
7443NA
electrical problems.
Fuses and circuit breakers protect
power devices in the vehicle.
Replace a bad fuse with a new one
of the identical size and rating.
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
10-33