Chevrolet 2013 Cruze Owner's Manual page 36

2-8 Keys, Doors, and Windows
6. Remove the transmitter from the
transmitter slot and press
To program additional
transmitters, repeat Steps 4 6.
When all additional transmitters
are programmed, press and hold
the ignition for 10 seconds to
exit programming mode.
Replace the plastic trim piece
from the small storage area.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak, the
DIC may display NO REMOTE
DETECTED when you try to start
the vehicle. The REPLACE
BATTERY IN REMOTE KEY
message may also be displayed at
this time.
.
To start the vehicle:
1. Remove the plastic trim piece
from the small storage area next
to the accessory power outlet
toward the front of the console,
to access the transmitter slot.
2. Push the button on the
recognized transmitter to extend
the key blade. Insert the key
blade into the transmitter slot.
I n f o r ma t i o n P r o v i d e d b y :
3. With the vehicle in P (Park) or
N (Neutral), press the brake
pedal and the ignition button.
See Starting the Engine on
page 9 18 for additional
information about the vehicle's
keyless ignition with pushbutton
start.
Replace the transmitter battery
as soon as possible.
Battery Replacement
Replace the battery if the REPLACE
BATTERY IN REMOTE KEY
message displays in the DIC. See
Replace Battery in Remote Key
under Key and Lock Messages on
page 5 29.
The battery is not rechargeable. To
replace the battery:
1. Push the button on the
transmitter to extend the key
blade.