Memory Channel; Memory Read Mode - AOR AR2300 Operating Manual

FFT frequency step
Threshold level (signal detection level)
FF
LC
(Note: The FS, FT commands cannot be used alone.
They must always be used in conjunction with the FF command.)

4-4 Memory channel

The AR2300 features 2,000 memory channels (50 channels in each of the 40 banks).
The number of memory banks can be reconfigured between 5 ~ 95 (in 5 incremental).

4-4-1 Memory read mode

MR MRnnmm
ZK
Go to previous memory channel
ZJ
To read: MRnnmm<CR>
FFnn FSnn FT-nnn
Search bank (two digits) select to access.
FFnn
nn: 00 ~ 39
Frequency step select
FSnn
nn: 00 ~ 10
00: 5kHz
01: 6.25kHz
02: 8.33kHz
03: 9kHz
04: 10kHz
05: 12.5kHz
06: 20kHz (default)
07: 25kHz
08: 30kHz
09: 50kHz
10: 100kHz
Set the threshold level. Once set, only signals over
FT-nnn
this level will be detected by the FFT search.
-nnn: (dB) (default: -80) (dB)
n: 0, 1
LCn
0: Disable search result frequency report
1: Enable search result frequency report
nn: 00 ~ 39 (Memory bank) (default: 00)
mm: 00 ~ 49 (Memory channel) (default: 00)
Go to next memory channel
(default: 00)
34