Yamaha YHT-S300 Owner's Manual page 23

page
The system settings
change automatically.
When "HDMI CONTROL" is set to
"ON", operations of the TV (for
example, changing channels, etc.) may
change the system settings, such as the
surround mode.
Set "HDMI CONTROL" to "OFF" or set
the system again by using its remote
control.
21
The remote control The system may be outside the remote For information on the remote control
does not operate the control operation range, operation range, refer to "Using the remote 12
system,
control".
The remote control sensor of this Change the lighting.
system may be exposed to direct
sunlight or lighting.
The batteries may be worn out. Replace the batteries. 4
• HDMI
page
"AUTO" set in the
setup menu "AUDIO
DELAY" does not
operate,
The TV does not support
automatically adjusting the audio
delay.
Adjust the delay time manually (0 to 240
INS).
19
The HDMI control
function does not
operate properly.
The number of the connected HDMI
components is over the limit.
Disconnect some of the HDMI
components.
No picture or sound The connected HDMI component does Connect the HDMI component that
not support high-bandwidth digital supports HDCP.
copyright protection (HDCP).
• Tuner
page
FM stereo reception is
noisy.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away, or
if the antenna quality is poor.
Check the antenna connections. 10
Try using a high-quality directional FM
antenna.
Set the reception mode to "MONO". 15
There is distortion, and
clear reception cannot
be obtained, even with
a good FM antenna.
There is multi-path interference.
Adjust the antenna position to eliminate
multi-path interference.
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is too weak.
Use a high-quality directional FM antenna.
Set the reception mode to "MONO" and
press TUNING _./_v to change
frequency by 1 step.
14, 15
23
En