Additional Information - Yamaha YHT-S300 Owner's Manual

ADDITIONAL INFORMATION
If there is any problem with the system, check the following items. If you cannot solve a problem with the
following remedies, or if the problem is not listed below, turn off and unplug the system, and then consult your
nearest authorized Yamaha dealer or Service Center.
page
Power turns on but
The power cable may be connected Make sure the power cable is plugged into
10
immediately shuts off. improperly,
the outlet firmly.
A speaker cable may be shorted. Make sure all speaker cables are connected
10
properly.
This system may have received a Set this system to standby mode, and then
strong electrical shock, such as from a disconnect the power cable. Wait tk_r about
12
lightening bolt or excessive static 3(1 seconds, connect the power cable, and
electricity, then turn the system on again.
The speakers make no
The volume may be set to minimum Adjust the volume level.
sound,
level. 12, 19
The mute function may be activated. Cancel the mute function. 12
The input source or input setting may Select the correct input source or input 12
be incorrect, setting.
The cables may be connected Make sure all cables are connected
10
improperly, properly.
"HDMI AUDIO" in the setup menu is Set "HDMI AUDIO" in the setup menu to 19
set to "TV". "AMP".
Sound is too low on The cables may be connected Make sure all cables are connected
one side. improperly, properly. 10
Speaker channels You may be listening to stereo sounds Press a surround mode button to enable the
13
other than the front without surround mode. sound field effect.
ones make no sound.
"SUR. LEVEL" in the setup menu is Adjust "SUR. LEVEL" in the setup menu. 19
set to minimum level.
The subwoofer makes
The volume of the subwoofer channel Adjust the volume level of the subwoofer. 7, 19
no sound, may be set to minimum level.
The source does not contain low-
frequency signals.
The volume level
You turned off the system when the
decreases without any volume level was over 70.
operation.
The volume level is automatically set to 70
the next time you turn on the system to
protect the speakers.
Sound is poor (noisy).
A speaker cable may be shorted.
Make sure all cables are connected
properly.
This system does not
operate properly.
This system may receive a strong
electrical shock, such as from a
lightening bolt or excessive static
electricity, or drop in power supply.
Set this system to standby mode, and then
disconnect the power cable. Wait tk_r about
3(1 seconds, connect the power cable, and
then turn on this system.
A digital or high-
frequency equipment
produces noises.
The system may be placed close to
digital equipment or high-frequency
equipment.
Place this system farther away from such
equipment.
10
12
22 E,