14
BRAKE SYSTEM
–
Cover painted parts.
–
Remove screw cap
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
308266-10
–
Mount the corresponding bleeder cover
Bleeder cover (00029013000) (
–
Connect the bleeding device.
Bleeding device (00029013100) (
308267-10
–
Open shut-off valve
Info
Follow the operating instructions of the bleeding device.
–
Ensure that the filling pressure is set on pressure gauge
sure on pressure regulator
Guideline
Filling pressure
201494-11
–
Pull off dust cap
Bleeding device (00029013100) (
–
Open bleeder screw
Info
Drain until fresh brake fluid emerges in the bleeder bottle hose without bub-
bles.
–
Tighten the bleeder screw.
–
Close shut-off valve
–
Open the bleeder screw again until no more brake fluid emerges.
Info
Overfilling of the brake fluid reservoir is prevented.
–
Tighten the bleeder screw. Remove the bleeder bottle hose. Attach the dust cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
308268-10
–
Stand the vehicle upright.
–
Correct the brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Refit screw cap with membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Check the foot brake lever for a firm pressure point.
308269-10
with membrane.
1
p. 189)
p. 186)
from the special tool set.
2
p. 189)
p. 189)
.
3
if necessary.
B
2... 2.5 bar (29... 36 psi)
of the bleeder screw. Connect the bleeder bottle hose.
4
p. 189)
by approximately one half turn.
5
.
3
.
A
p. 186)
74
. Correct the filling pres-
A