KTM 390 Duke EU 2013 Repair Manual page 22

6 FORK, TRIPLE CLAMP
–
Slide on lock ring
–
Grease and slide on seal ring
Lubricant (T511) (
Info
Mount with the sealing lip facing down and the open side facing up.
–
Slide on support ring
–
Sand the edges of sliding bushing
grease.
Fork oil (SAE 4) (48601166S1) (
–
Slide on sliding bushing
–
Warm up the outer tube in the lower sliding bushing area
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the sliding bushing with the longer shoulder of the special tool.
Mounting tool (T528S) (
–
Push the sliding bushing all the way into the outer tube.
202093-10
–
Position the support ring.
–
Hold the seal ring with the shorter shoulder of the special tool.
Mounting tool (T528S) (
–
Push the seal ring and support ring all the way into the outer tube.
202094-10
–
Mount lock ring
Info
The lock ring must engage audibly.
202095-10
–
Install dust boot
202096-10
.
2
.
3
p. 187)
.
4
with 600-grit sandpaper, then clean and
5
p. 186)
.
5
p. 197)
p. 197)
.
2
.
1
20
.
A